ماژول کنترل شارژ باتری مدل XH-M609

Input Voltage: DC 7~80V 

Control Accuracy: 0.1V

Power Consumption: <1.5W

Size: 57*42*19 mm (length*width*height)

Weight: 28g

VIN+: battery+

VIN-: battery -

VOUT+: positive of device/power supply system

VOUT-: negative of device/power supply system

Set and debug the module before connecting to the load. Watch the indicator light, on means there’s input, off means no input.

Set Stop Voltage

Long press on “-” button for five seconds to stop voltage value flashing, then press “+/-” button to set stop voltage value.

Start Control

Pressing the “+” button once, the indicator light will be on and input starts. Pressing the “+” button again, the indicator light will be off and input stops.

Mandatory Input for five seconds:

Long press on “+” button for three seconds to enter mandatory mode. Five seconds later it will automatically come to normal mode(stop voltage in normal mode is lower than battery voltage and protected lines will be automatically cut off after five seconds of mandatory input)

When the new battery is initially used, the rated voltage is close to actual value. To determine stop voltage, user can use general voltage calculation method of battery to calculate reasonable discharge voltage value.

When this module is used on the old battery, the actual voltage value and the rated voltage value differ greatly. User needs to measure stop voltage value in actual use.